Wheel Studs - Dual Rear Wheel (DRW): Installation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Position the new wheel stud, aligning the serrations in the wheel adapter flange made by the original wheel stud.
- Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut onto the wheel stud with the flat side against the washers.
- Tighten the wheel nut until the wheel stud head seats against the back side of the wheel extension flange.
- Remove the wheel nut and washers.
- Install the wheel and tire. For additional information, refer to WHEELS AND TIRES article.