Ball Joint: Installation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Using the special tools, install the upper ball joint.
- Using the special tools, install the lower ball joint.
- Install the snap ring in the groove at the bottom of the lower ball joint.
- If equipped, install the upper and lower ball joint grease fittings.
- Install the wheel spindle. For additional information, refer to Wheel Spindle .
CAUTION:
To avoid damage to components, do not use heat to aid installation.
NOTE:
Clean the wheel knuckle ball joint bores.
NOTE:
The upper ball joint must be installed first.