LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1304 (Electronic Engine Controls - Gasoline Engines) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the generator. For additional information, refer to GENERATOR AND REGULATOR article.
  2. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
  3. Remove the CHT sensor.
    • Coat the CHT sensor threads with high temperature nickel anti-seize lubricant prior to installation.
    • To install, tighten to 26 Nm (19 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals