LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Transmission Fluid Temperature (TFT) Sensor >> Removal

Transmission Fluid Temperature (TFT) Sensor: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission fluid pan gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter .
  2. Disconnect the Transmission Fluid Temperature (TFT) sensor connector.
    3. Fig 1: Locating Temperature (TFT) Sensor Electrical Connector
    G03889115Courtesy of FORD MOTOR CO.
  3. Press the tab, rotate the sensor counterclockwise and pull out.
    4. Fig 2: Identifying TFT Sensor
    G03889116Courtesy of FORD MOTOR CO.
  4. Inspect the O-ring. If the O-ring is damaged install a new TFT sensor.
scientia non olet · About LEMON Manuals