Transmission Filler Tube: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install a new transmission fluid filler tube O-ring.

Fig 1: Locating O-Ring Seal

Courtesy of FORD MOTOR CO.

NOTE: Coat the O-ring at the bottom of the transmission fluid filler tube with transmission fluid.

Install the transmission fluid filler tube.

Fig 2: Installing Transmission Fluid Filler Tube

Courtesy of FORD MOTOR CO.

Install the transmission fluid filler tube nut on the cylinder head.
- For 5.4L engines, tighten to 10 Nm (89 lb-in).
- For 6.8L engines, tighten to 28 Nm (21 lb-ft).
- For 6.0L engines, tighten to 8 Nm (71 lb-in).

Fig 3: Transmission Fluid Filler Tube Nut

Courtesy of FORD MOTOR CO.

Install the transmission filter tube vent on the intake manifold.
- For 5.4L and 6.8L engines, tighten to 10 Nm (89 lb-in).
- For 6.0L engines, tighten to 13 Nm (115 lb-in).
Install the transmission fluid level indicator.

Fig 4: Locating Fluid Level Indicator

Courtesy of FORD MOTOR CO.

Install the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.