LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Removal

Output Shaft Speed (OSS) Sensor: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the Output Shaft Speed (OSS) sensor connector.
    3. Fig 1: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
    G03889074Courtesy of FORD MOTOR CO.
    NOTE: Prior to removing the OSS, make sure that the area around the sensor is free of foreign material to prevent contamination of the transmission.
  3. Remove the OSS sensor.
    1. Remove the bolt.
    2. Remove the OSS sensor.
    4. Fig 2: Identifying Output Shaft Speed (OSS) Sensor
    GF0006807Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals