Engine Mount: Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the motor mounts and loosely install the 8 motor mount-to-motor mount plate bolts.
Lower the engine.
Install the 2 engine mount removable studs.
- Tighten to 55 Nm (41 lb-ft).

Fig 1: Upper Motor Mount Stud

Courtesy of FORD MOTOR CO.

Tighten the 8 motor mount-to-motor mount plate bolts.
- Tighten to 80 Nm (59 lb-ft).

NOTE: The top retaining nut must be tightened first.

Install the 4 motor mount-to-crossmember nuts.
- Tighten to 90 Nm (66 lb-ft).
Install the 2 new exhaust flange nuts.
- Tighten to 40 Nm (30 lb-ft).

Fig 2: Locating Nuts On Exhaust Downpipe

Courtesy of FORD MOTOR CO.

Position back the cable and install the bolt. Install the RH fan stator stand-off.
- Tighten both to 47 Nm (35 lb-ft).

Fig 3: Identifying Cable and RH Fan Stator Stand-Off

Courtesy of FORD MOTOR CO.

Position the power steering pump and install the 2 bolts.
- Tighten to 25 Nm (18 lb-ft).

Fig 4: Identifying Power Steering Pump Bolts

Courtesy of FORD MOTOR CO.

Install the LH fan stator stand-off.
- Tighten to 47 Nm (35 lb-ft).

Fig 5: Identifying LH Fan Stator Stand-Off

Courtesy of FORD MOTOR CO.

Install the 2 upper power steering bolts.
- Tighten to 25 Nm (18 lb-ft).

Fig 6: Identifying Power Steering Pump Upper Mounting Bolts

Courtesy of FORD MOTOR CO.

Install the A/C compressor. For additional information, refer to CLIMATE CONTROL article.
Install the cooling fan stator and radiator. For additional information, refer to ENGINE COOLING article.
Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.