LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1295 (Engine - 6.0L (99P E-Series) Diesel) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the crankshaft front seal mounting surface.
  2. Apply threadlock to the outer circumference of the leading edge of the crankshaft.
    3. NOTE: New seal and wear sleeve must not be separated.
  3. Using the Crankshaft Front Seal and Wear Ring Installer, install the new oil seal and wear sleeve assembly.
    4. Fig 1: Installing Oil Seal And Wear Sleeve Assembly
    GF0005711Courtesy of FORD MOTOR CO.
  4. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
scientia non olet · About LEMON Manuals