Removal And Installation
WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
- Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
- Disconnect the ignition coil electrical connector.
- Remove the bolt and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.
- Apply dielectric compound to the inside of the coil boots.