LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Automatic Transmission - 4R70E/W, 4R75E/W) >> In-Vehicle Servicing >> 1-2 Accumulator >> Removal

1-2 Accumulator: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Drain transmission fluid and remove the transmission fluid pan and filter. For additional information, refer to Fluid Pan, Gasket and Filter .
  3. Compress the 1-2 accumulator cover and remove the accumulator piston retaining ring.
    4. Fig 1: Locating Accumulator Piston Retaining Ring
    G03888654Courtesy of FORD MOTOR CO.
    NOTE: Note the location of the 1-2 accumulator springs for reference during assembly.
  4. Remove the 1-2 accumulator.
    1. Remove the 1-2 accumulator cover.
    2. Remove the nested bottom inner and outer 1-2 accumulator springs.
    3. Remove the accumulator piston.
    4. Remove the upper 1-2 accumulator spring.
    5. Fig 2: Identifying 1-2 Shift Accumulator Assembly
    GF0003533Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals