LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1286 (Engine - 4.6L And 5.4L) >> In-Vehicle Servicing >> Oil Cooler >> Installation

Oil Cooler: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the tab on the oil filter adapter nests into the notch in the oil cooler.
  1. Position a new oil cooler on the oil filter adapter and install the threaded insert.
    • Tighten to 58 Nm (43 lb-ft).
  2. Install a new oil filter.
    • Tighten to 16 Nm (12 lb-ft).
  3. Connect the 2 coolant hoses to the oil cooler.
  4. Install the oil drain plug.
    • Tighten to 23 Nm (17 lb-ft).
    5. Fig 1: Engine Oil Drain Plug
    GF0002670Courtesy of FORD MOTOR CO.
  5. Fill the engine with clean engine oil.
  6. Fill and bleed the engine cooling system. For additional information, refer to ENGINE COOLING article.
scientia non olet · About LEMON Manuals