LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1286 (Engine - 4.6L And 5.4L) >> In-Vehicle Servicing >> Engine Oil Pressure (EOP) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the engine oil pressure (EOP) switch wiring harness retainer and electrical connector.
  3. Remove the EOP switch.
    • To install, tighten in 2 stages.
      • Stage 1: Tighten to 14 Nm (10 lb-ft).
      • Stage 2: Tighten and additional 180 degrees.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals