LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1284 (Engine Cooling) >> Removal And Installation >> Coolant Pump - 6.0L Diesel >> Removal

Coolant Pump - 6.0L Diesel: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cooling fan stator. For additional information, refer to Cooling Fan Stator - 6.0L Diesel .
  2. Loosen the 4 coolant pump pulley bolts.
  3. Rotate the drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.
    4. Fig 1: Rotating Accessory Drive Belt Tensioner Clockwise
    G03887093Courtesy of FORD MOTOR CO.
  4. Remove the 4 bolts and the coolant pump pulley.
  5. Remove the 4 bolts and the coolant pump.
    • Discard the O-ring seal.
  6. Clean and inspect the coolant pump sealing surfaces.
scientia non olet · About LEMON Manuals