Coolant Pump - 6.0L Diesel: Installation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new O-ring on the coolant pump.
- Position the coolant pump and install the 4 bolts.
- Tighten to 23 Nm (17 lb-ft).
- Position the coolant pump pulley and install the 4 bolts finger tight.
- Rotate the drive belt tensioner clockwise and install the accessory drive belt onto the coolant pump pulley.
- Tighten the 4 coolant pump pulley bolts.
- Tighten to 31 Nm (23 lb-ft).
- Install the cooling fan stator. For additional information, refer to Cooling Fan Stator - 6.0L Diesel .
NOTE:
Lubricate the new O-ring seal with clean engine coolant prior to installation.
NOTE:
Do not rotate the coolant pump housing once the coolant pump has been positioned in the cylinder block. Damage to the O-ring seal will occur.