LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1272 (Wipers And Washers) >> Removal And Installation >> Wiper Pivot Arm >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The windshield wiper pivot arm can be removed at any point in the wiper sweep without the use of tools.
  1. Release the pivot arm locking lever.
    1. Carefully raise the windshield wiper blade away from the windshield glass until it stops.
    2. Pull the locking lever away from the windshield wiper pivot arm.
    2. Fig 1: Windshield Wiper Arm & Locking Lever
    GF0011487Courtesy of FORD MOTOR CO.
  2. Lift the windshield wiper pivot arm from the windshield wiper mounting arm and pivot shaft.
    3. Fig 2: Windshield Wiper Arm
    GF0011488Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
  4. Adjust the windshield wiper pivot arm. For additional information, refer to Wiper Blade and Pivot Arm Adjustment .
scientia non olet · About LEMON Manuals