LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1271 (Instrument Cluster (Ic), Message Center, And Warning Chimes) >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the key to the ON position (do not start the engine).
  2. Wait until the safety belt warning indicator turns off (approximately 1 minute).
    3. NOTE: Steps 3 and 4 must be completed within 50 seconds or the procedure must be repeated.
  3. Buckle then unbuckle the safety belt 9 times, ending with the safety belt unbuckled. The safety belt warning indicator then illuminates for 3 seconds.
  4. Within 10 seconds of the safety belt warning indicator illuminating, buckle then unbuckle the safety belt. This enables the Belt-Minder® if disabled, or disables the Belt-Minder® if enabled.
  5. The safety belt warning indicator flashing 4 times per second for 3 seconds provides confirmation that the Belt-Minder® is disabled.
  6. The following sequence of events confirms the Belt-Minder® is enabled:
    • flashing of the safety belt warning indicator 4 times per second for 3 seconds
    • 3 seconds with the safety belt warning indicator off
    • flashing of the safety belt warning indicator 4 times per second for 3 seconds again
  7. After confirmation, the deactivation/activation procedure is complete.
scientia non olet · About LEMON Manuals