Removal And Installation

All seats 

1. Insert an appropriate tool into the slot and release the detachable safety belt anchor from the seat.
Fig 1: Inserting Appropriate Tool Into Slot & Releasing Detachable Safety Belt Anchor From Seat
Courtesy of FORD MOTOR CO.
2. Remove the seat.
   • Pull the seat latch release handle, slide the seat to the right and disengage from the seat latch striker.
Fig 2: Pulling Seat Latch Release Handle, Sliding Seat To Right & Disengaging From Seat Latch Striker
Courtesy of FORD MOTOR CO.

LH seat 

3. Remove LATCH attachment assembly.
   1. To install, tighten to 25 Nm (18 lb-ft).
   2. Release the 2 lower J-clips.
   3. Remove the LATCH attachment assembly.
Fig 3: Quad Bucket Left Seat LATCH Components
Courtesy of FORD MOTOR CO.
4. Remove the 4 nuts and pedestal.
   • To install, tighten to 25 Nm (18 lb-ft).

RH seat 

NOTE: The anti-rotation tab must be correctly aligned for correct installation.
5. Remove the bolt and detachable safety belt anchor.
   • To install, tighten to 40 Nm (30 lb-ft).
   • Remove the locator spacer.

All seats 

6. Remove the 3 screws and LH cushion side shield.
7. Remove the 3 screws and RH cushion side shield.

RH seat 

8. Position the seat forward on the seat track and remove the 4 seat track-to-cushion bolts.
   • To install, tighten to 25 Nm (18 lb-ft).
Fig 4: Locating Seat Track-To-Cushion Bolts
Courtesy of FORD MOTOR CO.

LH seat 

9. Remove the 4 seat riser-to-cushion frame bolts.
   • To install, tighten to 25 Nm (18 lb-ft).

All seats 

10. Separate and remove the cushion assembly.
11. To install, reverse the removal procedure.