Selector Lever Bezel: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Selector lever removed for clarity.

Install the selector lever bezel. Be sure the tabs are correctly fastened on the selector lever.

Fig 1: Identifying Tabs

Courtesy of FORD MOTOR CO.

Install the selector lever bezel light in the selector lever bezel.

Fig 2: Identifying Selector Lever Bezel

Courtesy of FORD MOTOR CO.

Install the selector lever knob and the 2 screws.

Fig 3: Identifying Screws

Courtesy of FORD MOTOR CO.

Install the selector lever knob trim covers.

Fig 4: Identifying Trim Covers

Courtesy of FORD MOTOR CO.

Connect the power outlet electrical connector.

Fig 5: Identifying Connector

Courtesy of FORD MOTOR CO.

Install the center console finish panel.

Fig 6: Identifying Center Console Finish Panel

Courtesy of FORD MOTOR CO.

Install the center console compartment tray.

Fig 7: Identifying Center Console Compartment Tray

Courtesy of FORD MOTOR CO.

Install the upper selector lever trim ring.

Fig 8: Identifying Shift Lever Trim Ring

Courtesy of FORD MOTOR CO.