Removal And Installation
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Disconnect the brake flexible hose fitting from the wheel cylinder.
- To install, tighten to 15 Nm (11 lb-ft).
- Remove the brake flexible hose bracket bolt.
- To install, tighten to 17 Nm (13 lb-ft).
- Disconnect the brake tube fitting from the brake flexible hose.
- To install, tighten to 15 Nm (11 lb-ft).
- Remove the flexible hose clip and the brake hose.
- To install, tighten to 15 Nm (11 lb-ft).
- To install, reverse the removal procedure.
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.