LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1202 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the upper radiator hose from the 2 retaining clips on the cooling fan shroud.
    • Position the hose aside.
  2. Remove the 4 upper radiator support bracket bolts.
    • To install, tighten to 10 Nm (89 lb-in).
  3. Remove the oil level indicator.
  4. Remove the stud bolt and then remove the oil level indicator tube by guiding it between the radiator support and the cooling fan.
    • Remove and discard the O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
    5. NOTE: Install a new O-ring seal and lubricate with clean engine oil.
    NOTE: Installation of the oil level indicator may require the assistance of a second technician to align the tube with the orifice.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals