LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1190 (Manual Transmission) >> In-Vehicle Servicing >> Vehicle Speed Sensor (VSS) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
    2. NOTE: The electrical connector and the vehicle speed sensor (VSS) are accessed from the top of the transaxle.
  2. Remove the VSS bolt.
  3. Disconnect the electrical connector and remove the VSS.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals