Removal And Installation
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The battery zone valve is not interchangeable with the passenger zone valve.
- Remove the auxiliary climate control housing. For additional information, refer to Auxiliary Climate Control Housing .
- Remove the 2 battery zone valve screws.
- To install, tighten to 2 Nm (18 lb-in).
- Loosen the nuts and disconnect the battery zone valve tube-O fittings.
- Discard the O-ring seals.
- To install, tighten to 17 Nm (13 lb-ft).
- Disconnect the electrical connector and remove the battery zone valve.
- To install, reverse the removal procedure.
- Install new O-ring seals.