LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1164 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Cowl Panel Grille >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 wiper pivot arms nuts.
    • To install, tighten to 35 Nm (26 lb-ft).
  2. Remove the LH and RH wiper pivot arms.
  3. Remove the LH and RH cowl end cap pushpin retainers.
  4. Remove the cowl end caps.
  5. Release the cowl panel grille from the retaining clips and remove the cowl panel grille.
  6. To install, reverse the removal procedure.
    • Adjust the wiper pivot arms. For additional information, refer to WIPERS AND WASHERS article.
scientia non olet · About LEMON Manuals