LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1132 (Instrument Cluster System And Panel Illumination) >> Diagnostic Tests >> Instrument Cluster and Panel Illumination >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Chart

Condition Possible Sources Action
  • No communication with the smart junction box (SJB)
  • Fuse(s)
  • Wiring, terminals or connectors
  • SJB
  • The control illumination is inoperative - all hardwired illumination
  • Fuse
  • Wiring, terminals or connectors
  • SJB
  • The control illumination is always on - all hardwired illumination
  • Wiring, terminals or connectors
  • SJB
  • All instrument panel illumination does not dim
  • Wiring, terminals or connectors
  • Instrument panel dimmer switch
  • SJB
  • The steering wheel control illumination is inoperative
  • Wiring, terminals or connectors
  • Steering wheel control switch(es)
  • Steering wheel control switch harness
  • Clockspring
  • The memory set switch illumination is inoperative
  • Wiring, terminals or connectors
  • Memory set switch
  • Drivers seat module (DSM)
  • The window control switch illumination is inoperative
  • Wiring, terminals or connectors
  • Window control switch
  • The door lock control switch illumination is inoperative
  • Wiring, terminals or connectors
  • Door lock control switch
  • All network-controlled illumination does not dim
  • Medium speed controller area network (MS-CAN)
  • SJB
  • CARRY OUT the network test.
    • If the scan tool communicates with the modules on the MS-CAN, INSTALL a new SJB. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.
  • The instrument cluster illumination is inoperative
  • Instrument cluster
  • CHECK the audio unit illumination for correct operation.
    • If the audio unit illumination operates correctly, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation.
    • If the audio unit illumination does not operate correctly, REFER to MODULE COMMUNICATIONS NETWORK to continue diagnosis of the communications network.
  • The audio unit illumination is inoperative
  • Audio unit
  • CHECK the instrument cluster illumination for correct operation.
    • If the instrument cluster illumination operates correctly, REMOVE the audio unit. REFER to INFORMATION AND ENTERTAINMENT SYSTEMS . SEND it to an authorized repair facility. TEST the system for normal operation after the repair.
    • If the instrument cluster illumination does not operate correctly, REFER to MODULE COMMUNICATIONS NETWORK to continue diagnosis of the communications network.
  • The digital versatile disk (DVD) player illumination is inoperative
  • DVD player
  • The electronic automatic temperature control (EATC) illumination is inoperative
  • EATC module
  • The individual component illumination is inoperative
  • Wiring, terminals or connectors
  • Floor shifter
  • LH rear heated seat switch (if equipped)
  • RH rear heated seat switch (if equipped)
  • Manual temperature control (if equipped)
  • Message center switch (if equipped)
  • Memory set switch (MKX)
  • Window adjust switches (MKX)
  • Headlamp switch
  • Hazard/passenger air bag disable/traction control switch (if equipped)
  • Door lock control switches (MKX)
  • Power liftgate release switch (MKX)
  • Roof opening panel switch (if equipped)