Brake Discs

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Using an impact tool without a torque socket will lead to unevenly torqued lug nuts. This causes brake disc on-vehicle lateral runout and brake roughness.

NOTE: It is generally not necessary to install new brake discs to address noise issues.

Remove the brake discs. Refer to FRONT DISC BRAKE for front brake discs or REAR DISC BRAKE for rear brake discs.
Inspect the brake discs and measure the brake disc thickness in a minimum of 4 places around the circumference of the brake disc. Record the measurements.
- Install new brake discs if any thickness measurement is less than the minimum specification. Refer to FRONT DISC BRAKE for front brake discs or REAR DISC BRAKE for rear brake discs.
- Install new brake discs if cracked.
- Machine the brake discs if the diagnosis has revealed vibration in the steering wheel, seat or pedal while braking. Heavily scored brake discs, similar to that caused by pads worn down to the backing plate, should also be machined. In order to machine, discs must be above the minimum thickness to machine specification. Refer to FRONT DISC BRAKE for front brake discs or REAR DISC BRAKE for rear brake discs.