Disabling Unlimited Key Mode

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: By disabling the unlimited key mode, the previous access code no longer operates the vehicle.

From the scan tool, follow the on-screen instructions to ENTER SECURITY ACCESS. For additional information, refer to Anti-Theft Security Access .
Select: "unlimited key mode OFF" and press the tick mark.
Select: "Ignition Key Code Erase" and press the tick mark.
Disconnect the scan tool and turn the ignition switch to OFF.
Insert the first PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds (6 seconds if it is an IKT key).
Remove the first PATS key from the ignition lock cylinder.
Insert the next PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds (6 seconds if it is an IKT key).

NOTE: With the unlimited key mode turned off, a maximum of 8 keys can be programmed into the IC using the Key Programming Using Two Programmed Keys procedure. The PID SPARE KEY must be enabled.

If it is desired to program additional key(s), refer to Key Programming Using Two Programmed Keys for each additional key that needs to be programmed. The PID SPARE KEY must be enabled.