Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Remove the B-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Use the half-inch drill with integral stop to drill out the damaged threads in the upper pillar structure.

Fig 1: Using Half-Inch Drill With Integral Stop To Drill Out Damaged Threads In Upper Pillar Structure

Courtesy of FORD MOTOR CO.

NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.

Apply a suitable lubricant to the M14 x 1.5 tap with integral stop and tap new threads.

Fig 2: View Of Integral Stop Thread Tap

Courtesy of FORD MOTOR CO.

Use a threaded insert and screw it into the retapped hole until it is slightly below the surface.

Fig 3: View Of Threaded Insert For Retapped Hole

Courtesy of FORD MOTOR CO.

Use a hammer to lightly tap the installation tool several times to seat the insert keys.

Fig 4: Tapping Installation Tool To Seat Insert Keys

Courtesy of FORD MOTOR CO.

If the bolt(s) on the height adjuster is not stripped, reinstall the original safety belt shoulder height adjuster. If the bolt(s) is stripped, install a new safety belt shoulder height adjuster. For additional information, refer to Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts or Safety Belt Shoulder Height Adjuster .