LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1116 (Warning System) >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition lock cylinder to the ON position (do not start the engine).
  2. Wait until the safety belt warning lamp turns off (approximately 1 minute).
    3. NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off.
  3. For the seating position being disabled, at a moderate rate, buckle then unbuckle the safety belt 9 times, ending with the safety belt in the unbuckled state. After this step the safety belt warning indicator illuminates for 3 seconds.
  4. Within 10 seconds of the safety belt warning indicator turning on, at a moderate rate, buckle then unbuckle the safety belt.
    • This disables the Belt-Minder® feature for that seating position, if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
    • This enables the safety Belt-Minder® feature for that seating position, if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the indicator off, then the safety belt warning indicator flashes 4 times per second for 3 seconds again.
  5. After confirmation, the deactivation/activation procedure is complete.
scientia non olet · About LEMON Manuals