Instrument Cluster Messages

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Whenever a message is suspected as missing, confirmed by a missing message DTC, it is important to look for other symptoms that may also be present in the instrument cluster and throughout the vehicle. Once a DTC is set in the instrument cluster it may be helpful to review the complete message list available in MODULE COMMUNICATIONS NETWORK to see what other modules also rely on the same message and run the self-test for those modules. If the message is missing from other modules, the same DTC may also be set in those modules. Confirmation of missing messages common to multiple modules may indicate that the originating module is the source of the concern or the communication network may be experiencing some problems.

The instrument cluster uses input messages from other modules to control the gauges, informational indicators, warning indicators and warning chime output over the communication networks. If a required message is missing or invalid for less than 5 seconds, the gauge or indicator that requires the message remains at the last commanded state based upon the last known good message. For example, if the O/D off status message is missing for less than 5 seconds and the O/D off indicator was ON (O/D cancelled), the indicator remains in the ON state until the next good message is received. If the message remains missing or invalid for greater than 5 seconds, the instrument cluster sets a U-code DTC and the output becomes a default action for the indicator or gauge. Each indicator or gauge utilizes a different default strategy depending on the nature of the indication. Refer to INSTRUMENT CLUSTER normal operation descriptions located before each individual pinpoint test for further description of the default action specific to each indicator or gauge. If the messaged input to the cluster returns at any time, the normal function of the gauge or indicator resumes.