LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Supplemental Inflatable Restraint System) >> Removal And Installation >> Passenger Air Bag Module - MKX >> Installation

Passenger Air Bag Module - MKX: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not install the passenger air bag module electrical connectors by the locking buttons. Damage to the locking buttons may occur.
    CAUTION: The passenger air bag module electrical connector locking buttons must be in the released position when the connector is being installed or connector damage may occur.
    CAUTION: The passenger air bag module electrical connectors are unique and cannot be reversed when connected to the passenger air bag module. Match the electrical connector key to the keyway in the passenger air bag module. Do not force the electrical connectors into the passenger air bag module. Damage to the connector or component may occur.
    NOTE: RH side shown, LH similar.
  1. Position the passenger air bag module on the cross vehicle beam. With the locking buttons released, install the 2 passenger air bag module electrical connectors fully into the passenger air bag module and seat the locking buttons.
    2. Fig 1: Locating Passenger Air Bag Module Electrical Connectors
    GF0028601Courtesy of FORD MOTOR CO.
    NOTE: During the passenger air bag module installation, make sure all 7 of the module hooks are fully seated in the I/P.
  2. Install the passenger air bag module 7 hooks into the I/P. Raise the rear of the passenger air bag module onto the 3 mounting studs.
    3. Fig 2: Identifying Hooks On I/P
    GF0031225Courtesy of FORD MOTOR CO.
  3. Install the 3 passenger air bag module nuts.
    • Tighten to 7 Nm (62 lb-in).
    4. NOTE: To avoid a squeak or rattle condition, install the passenger air bag module bracket and passenger air bag module bolts in this order.
  4. Install the passenger air bag module support bracket.
    1. Install the passenger air bag module support bracket and 2 bolts to the cross vehicle beam.
      • Tighten to 8 Nm (71 lb-in).
    2. Install the inboard passenger air bag module support bracket-to-passenger air bag module bolt.
      • Tighten to 8 Nm (71 lb-in).
    3. Install the outboard passenger air bag module support bracket-to-passenger air bag module bolt.
      • Tighten to 8 Nm (71 lb-in).
    5. Fig 3: Installing Passenger Air Bag Module Support Bracket Bolts In Sequence
    GF0031234Courtesy of FORD MOTOR CO.
  5. Install the screw and the RH duct assembly.
  6. Install the screw and the LH duct assembly.
  7. Install the screw for the LH duct assembly bracket in the front of the I/P.
    8. NOTE: Make sure the RH I/P finish panel 5 retaining clips are fully seated in the I/P.
  8. Install the RH I/P finish panel.
  9. Install and close the glove compartment door.
    • If equipped, attach the glove compartment door dampener.
  10. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
scientia non olet · About LEMON Manuals