Passenger Air Bag Deactivation (PAD) Indicator - Edge
WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 13D730 | Passenger airbag deactivation (PAD) indicator |
| 2 | 04302 | Instrument panel (I/P) center finish panel |
| 3 | - | Passenger airbag deactivation indicator electrical connector (part of 14401) |
WARNING:
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
NOTE:
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
NOTE:
The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:
The passenger air bag deactivation indicator is part of the hazard switch/traction control switch assembly.
- Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
- Pull out to release the 8 retaining clips and detach the instrument panel (I/P) center trim panel.
- Disconnect the passenger air bag deactivation indicator electrical connector.
- Release the 4 locking tabs (2 upper and 2 lower) on the passenger air bag deactivation indicator and remove it from the I/P center finish panel.
- To install, reverse the removal procedure.
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .