LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Seat System) >> Removal And Installation >> Seat Cushion - Rear, 60 Percent

Seat Cushion - Rear, 60 Percent

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

All seats 

  1. Remove the 60 percent seat. For additional information, refer to Seat - Rear, 60 Percent .

    2. Seats equipped with heat 

  2. Disconnect the 2 heater mat electrical connectors. Separate the 2 heater mat electrical connectors from the backrest assembly.

    3. All seats 

  3. Release the tab and remove the outboard cushion frame pivot bracket cover.
  4. Release the tab and remove the inboard cushion frame pivot bracket cover.
  5. Remove the 2 cushion frame pivot bracket bolts and the cushion assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals