Seat - Rear, 60 Percent: Removal

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Keep hands clear of all moving seat mechanisms when releasing the recliner lever. The recliners are spring loaded and release with high force. Failure to follow these instructions may result in serious personal injury.

WARNING: Follow all seat recliner synchronization steps exactly as indicated. Always verify correct seat recliner alignment. Any misalignment may adversely affect seat back and seat retractor performance in a crash. Failure to follow these steps may result in serious personal injury to the vehicle occupant(s).

WARNING: Always keep the seat back in the upright position while installing the seat and when tightening all retainers to specification. Always verify correct seat recliner alignment. Correct seat recliner alignment is critical for correct seat and safety belt retractor operation in a crash. Failure to follow these instructions may result in serious personal injury to the vehicle occupant(s).

NOTE: When removing the 60 percent seat, the 40 percent seat must be removed first to gain access to the 60 percent seat backrest assembly anchor bracket-to-floor nuts.

Remove the 40 percent seat. For additional information, refer to Seat - Rear, 40 Percent .
Position the 60 percent seat backrest in the upright position.
Remove the outboard bolt cover.
Remove the kneeling assembly rubber stud cap (if equipped).
Remove the kneeling assembly-to-floor nut and bolt.
Pivot the 60 percent seat cushion upward.
Disconnect the heated seat (if equipped) and the power-fold actuator (if equipped) electrical connector.
Remove the 5 backrest assembly anchor bracket-to-floor nuts.
Lift out and remove the load floor from the cargo area.
Through the rear hatch, remove the 2 rear tie-down-to-floor nuts.
Remove the 60 percent seat through the back hatch.