LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Seat System) >> Removal And Installation >> Lumbar Assembly - Manual >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats 

  1. Position the seat to access all the seat track-to-floor bolts and the safety belt retractor belt anchor nut.
  2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
  3. Remove the front seat. For additional information, refer to Seat - Front .
  4. Remove the cushion side shield in the following sequence.
    1. If equipped with manual recline, release the clip and remove the manual recline handle.
    2. If equipped with manual height adjust, pull and remove the manual height adjust handle.
      3. NOTE: Release the tension on the manual lumbar cable before removing the manual lumbar handle.
    3. Release the 2 clips on the back of the manual lumbar handle then pull and remove the manual lumbar handle.
    4. Remove the cushion side shield screw(s).
    5. If equipped with power seat track, slide the cushion side shield up in the rear to release the retainer.
    6. Slide the cushion side shield forward to disengage the retainer.
      • If equipped with manual seat tracks, remove the cushion side shield.
    7. If equipped with power seat tracks, disconnect the seat control switch electrical connector.
      • Remove the cushion side shield.
  5. Remove the lumbar cable from the manual lumbar adjuster in the following sequence.
    1. Remove the manual lumbar adjuster to bracket screw.
    2. Separate the manual lumbar adjuster from the bracket.
    3. Remove the lumbar cable from the manual lumbar adjuster.
  6. Release the backrest trim cover J-clips.
    7. Fig 1: Identifying Backrest Trim Cover J-Clips
    GF0030874Courtesy of FORD MOTOR CO.
    NOTE: RH side shown, LH similar.
  7. Release the LH and RH backrest trim cover tether from the backrest frame.
    8. Fig 2: Identifying LH & RH Backrest Trim Cover Tether
    GF0030875Courtesy of FORD MOTOR CO.
  8. Pull out at the bottom and detach the 2 lower hard back panel pin-type retainers.
  9. Slide the hard back panel out of the backrest trim cover.
  10. Release the manual lumbar hooks from the backrest frame, route out the manual lumbar cable and remove the manual lumbar assembly.
  11. To install, reverse the removal procedure.
  12. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.  For additional information, refer to Seat - Front .

    13. Passenger seat 

  13. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
scientia non olet · About LEMON Manuals