LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Seat System) >> Removal And Installation >> Heated Seat Switch - Rear Seat >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door handle bezel on the side of the affected switch in the following sequence.
    1. Remove the rear door handle bezel screw cover.
    2. Remove the rear door handle bezel screw.
    3. Separate the rear door handle bezel from the door trim panel.
  2. Disconnect the electrical connector, release the clips and remove the heated seat switch from the back side of the rear door handle bezel.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals