LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Seat System) >> Disassembly And Assembly >> Seat Cushion - Rear, 40 Percent >> Disassembly And Assembly

Disassembly And Assembly

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 40 percent seat. For additional information, refer to Seat - Rear, 40 Percent .
  2. Remove the 40 percent seat cushion. For additional information, refer to Seat Cushion - Rear, 40 Percent .
  3. Remove the 2 kneeling assembly-to-cushion frame bolts. Remove the kneeling assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. Release all the cushion trim cover-to-cushion frame retainers and remove the cushion foam pad and cushion trim cover.
    5. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from the cushion foam pad.
  5. Remove the cushion trim cover in the following sequence.
    1. Feed the heater mat wire harness and electrical connectors back through the cushion trim cover (if equipped).
    2. Release the hook-and-loop strips.
    3. Separate the cushion trim cover wire retainer from the clips in the cushion foam pad and remove the cushion trim cover.
  6. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals