LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Seat System) >> Diagnostic Tests >> Seats >> Pinpoint Tests >> Pinpoint Test B: The Power Seat is Inoperative - Driver, Without Power Recliner >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The driver seat control switch is powered by battery voltage on circuit SBB60 (GN/RD) and is supplied ground on circuit GD145 (BK/BU). When pressed, the seat control switch supplies that voltage and ground to a power seat track motor to move the seat. When pressed in the opposite direction, the seat control switch reverses the polarity to that same power seat track motor, which moves the seat in the opposite direction. There are 3 power seat track motors that combine to move the seat cushion horizontally (forward/rearward) and vertically (front up/down and rear up/down). If a new seat track motor needs to be installed, it is necessary to install an entire power seat track.

scientia non olet · About LEMON Manuals