Instrument Cluster Finish Panel

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Edge only

Remove the upper instrument panel center finish panel.
- Using a suitable tool, gently pry out the upper center finish panel to disengage the clips.
- Remove the upper center finish panel.
- Disconnect the electrical connectors.

All vehicles

Lower the steering column to the full down position.
Remove the steering column opening cover.
- Remove the 2 steering column opening cover screws.
- Disengage the steering column opening cover from the retainers.
- Disconnect the electrical connector and tube, if equipped.

Fig 1: Locating Electrical Connector, Tube & Steering Column Opening Cover

Courtesy of FORD MOTOR CO.

Remove the 2 cluster finish panel screws.

Fig 2: Locating Cluster Finish Panel Screws

Courtesy of FORD MOTOR CO.

Disengage the cluster finish panel from the retaining clips and remove the panel.
- Disconnect the electrical connectors, if equipped.
To install, reverse the removal procedure.