Digital Versatile Disc (DVD) Player: Removal
WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Programmable module installation (PMI) only needs to be carried out if the DVD player is being replaced.
- Upload the DVD player configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION .
- Remove the 4 screws.
- Remove the DVD player.
- Pull down on the sides of the DVD player to disengage the clips from the bracket.
- Using a suitable tool, push the rear most U-hook forward and release the U-hooks.
- Hang the DVD player on the J-hooks and disconnect the electrical connector.
- Remove the DVD player from the J-hooks.
NOTE:
Open the DVD player display.