Quarter Trim Panel

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

LH side with power liftgate

Remove the cover and the switch from the LH quarter trim panel.
- Disconnect the electrical connector.

Fig 1: Identifying LH Quarter Trim Panel

Courtesy of FORD MOTOR CO.

Remove the power liftgate rod-to-liftgate cover and nut.
- To install, tighten to 11 N.m (8 lb-ft).

Fig 2: Identifying Strut From Liftgate

Courtesy of FORD MOTOR CO.

All vehicles

Remove the rear cargo load area.
- Remove the foam blocks from the spare tire well.

NOTE: Inspect the safety belt lower anchor bolt cover for damage. If the safety belt lower anchor bolt cover does not remain in place, install a new cover.

Remove the safety belt lower anchor bolt cover and remove the safety belt lower anchor bolt.
- To install, tighten to 54 N.m (40 lb-ft).

NOTE: Make sure the push pin retainers are removed with the quarter trim panel.

Remove the RH or LH quarter trim panel.
- Disconnect the electrical connectors, if equipped.
To install, reverse the removal procedure.