LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1104 (Interior Trim And Ornamentation) >> Removal And Installation >> C-Pillar Trim Panel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
  1. Remove the safety belt D-ring cover and remove the safety belt bolt.
    • To install, tighten to 54 N.m (40 lb-ft).
  2. Remove the screw cover.
  3. Remove the screw.
    • To install, tighten to 9 N.m (80 lb-in).
  4. Position the quarter trim panel aside to allow C-pillar trim panel removal.
  5. Remove the C-pillar trim panel.
    • Pull outward and downward to remove the panel.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals