A-Pillar Trim Panel

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The A-pillar trim panel is held in place by a clip that is snapped to the back of the panel. A new clip must be installed when installing the existing trim panel.

NOTE: The A-pillar trim panel is held in place by a tether that is snapped to the back of the panel.

Remove the A-pillar trim panel and disconnect the tether.

Fig 1: Locating A-Pillar Trim Panel

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.