Instrument Cluster (IC): Removal

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: When installing a new instrument cluster, it is necessary to upload the module configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION .

Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Remove the 2 screws and the lower steering column cover.
- If equipped, disconnect the ambient air temperature sensor air hose and electrical connector.
Tilt the steering column to the lowest position.

Edge

NOTE: The instrument panel center finish panel is held in place by spring clips located on the finish panel.

Pull the instrument panel center finish panel straight out to release the retaining tabs and position aside.

All vehicles

Release the 4 locating tabs on the instrument cluster finish panel gap hiding reveal from the upper steering column cover.

Fig 1: Identifying Locating Tabs On Instrument Cluster Finish Panel Gap

Courtesy of FORD MOTOR CO.

NOTE: The upper section of the instrument cluster finish panel is held in place by spring clips located on the finish panel.

Remove the 2 screws and the instrument cluster finish panel.
- If equipped, disconnect the power liftgate switch electrical connector.
Remove the 4 screws and the instrument cluster.
- Disconnect the electrical connector.