Intermittent Speed Windshield Wipers

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The intermittent wiper speed is activated with grounds controlled by the multi-function switch inputs to the windshield wiper motor module. The windshield wiper motor module then activates the windshield wiper run/park relay coil and switches voltage through the windshield wiper high/low relay. The HI/LO relay remains deactivated supplying the voltage through the windshield wiper motor low-speed input and activates the windshield wiper motor. When the windshield wiper motor module receives the grounded input, the motor continues to operate until the Hall-effect sensor senses magnetism, which turns off the run/park sensor output to the windshield wiper run/park software, deactivating the relay and disconnecting voltage to the wiper motor. The windshield wipers remain parked until the windshield wiper motor module completes a time-out and then repeats the intermittent windshield wiper cycle.