LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1094 (Handles, Locks, Latches And Entry Systems) >> General Procedures >> Keyless Entry Keypad Code Programming >> Erasing the Personal Codes

Erasing the Personal Codes

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the wrong code has been entered 7 times (35 consecutive button presses), the keypad will go into an anti-scan mode. This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after one minute of keypad inactivity, after pressing the UNLOCK control on the IKT, or after the ignition key has been turned to the ON position.
  1. Enter the permanent factory keyless entry keypad code.
  2. Within 5 seconds, press the 1/2 button on the keypad and release.
  3. Within 5 seconds, press and hold the 1/2 button on the keypad for 2 seconds.
  4. All personal codes are now erased and only the permanent factory keyless entry keypad code will work.
scientia non olet · About LEMON Manuals