Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the power liftgate rod assembly. For additional information, refer to Power Liftgate Rod .
- Disconnect the power liftgate motor electrical connectors.
- Remove the power liftgate motor retaining bolts and remove the power liftgate motor assembly.
- To install, tighten to 11 N.m (8 lb-ft).
- Position the back end of the rear quarter trim out enough to access the top power liftgate motor retaining bolt.
- To install, reverse the removal procedure.
- Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization .