Power Liftgate Awake/Sleep Status
WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- The LTM is in the awake state whenever the ignition is in the RUN position.
- The LTM is in the awake state while carrying out a close or an open operation, including cinch.
- The LTM is in the sleep state when all of the following conditions exist:
- The latch is not in the fully unlatched position
- The ignition is in the OFF position
- No power operation is active
- No wake up inputs have changed state for more than 20 seconds
- The LTM is also in the sleep state when all of the following conditions exist:
- The latch is in the unlatched position
- The ignition is in the OFF position
- No power operation is active
- No wake up inputs have changed state for more than 6 hours
The wake up inputs for the power liftgate are:
- Power liftgate open/close switch request signal
- Fork bolt primary signal
- Fork bolt secondary signal
- Detent switch signal
- Rear control switch
- Exterior handle switch
- Glass ajar switch
- CAN