LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1093 (Body Panel System - Body Closures) >> Diagnostic Tests >> Power Liftgate >> Pinpoint Tests >> Pinpoint Test E: The Power Liftgate Chime is Inoperative >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The power liftgate chime is controlled by the liftgate/trunk module (LTM). To activate the chime, the LTM supplies a high frequency voltage output on circuit CPR56 (VT/BN) and ground on circuit RPR56 (GY/VT).

If chime output is 0.4VDC less than chime output feedback and voltage is greater than 3.5V, the chime will not be activated and the LTM sets this DTC.

If feedback voltage is greater than 3.3VDC for more than 500ms, chime activation is disabled and the LTM sets this DTC.

If diagnostic feedback voltage is less than 0.9VDC for PWM duty greater than 80%, the LTM sets this DTC.

This pinpoint test is intended to diagnose the following: