Selector Lever Knob: Removal

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

MKX

Using a suitable tool, remove the selector lever trim ring.

Fig 1: Locating Selector Lever Trim Ring

Courtesy of FORD MOTOR CO.

All vehicles

Lift the armrest. Using a suitable tool, remove the center console trim cover.

Fig 2: Identifying Center Console Trim Cover

Courtesy of FORD MOTOR CO.

NOTE: Center console side trim cover removed for clarity.

Disconnect the transmission control (TC) switch electrical connector.

Fig 3: Locating Transmission Control (TC) Switch Electrical Connector

Courtesy of FORD MOTOR CO.

Remove and discard the selector lever knob trim covers by carefully prying out on the bottom front corners and then pry out on the top front corner and remove the covers.

Fig 4: Removing Selector Lever Knob Trim Covers By Carefully Prying Out On Bottom Front Corners

Courtesy of FORD MOTOR CO.

NOTE: Inspect the knob body for damage. Install a new knob body if necessary.

Remove and discard the 2 selector lever knob screws and remove the selector lever knob while routing the TC switch electrical connector harness out of the selector lever.

Fig 5: Removing Selector Lever Knob While Routing TC Switch Electrical Connector Harness Out Of Selector Lever

Courtesy of FORD MOTOR CO.