LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Automatic Transmission External Controls) >> Removal And Installation >> Selector Lever Knob >> Installation

Selector Lever Knob: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Route the TC switch electrical connector harness through the selector lever and install the shift knob and 2 new screws. Loosely install both screws before tightening.
    • Tighten to 2 Nm (18 lb-in)
    2. Fig 1: Routing TC Switch Electrical Connector Harness Through Selector Lever
    GF0032011Courtesy of FORD MOTOR CO.
    NOTE: Be sure that the shift knob bezel is correctly installed on the shift knob.
  2. Install new selector lever knob trim covers.
    3. Fig 2: Installing Selector Lever Knob Trim Covers
    GF0032012Courtesy of FORD MOTOR CO.
    NOTE: Center console side trim cover removed for clarity.
  3. Connect the transmission control (TC) switch electrical connector.
    4. Fig 3: Locating Transmission Control (TC) Switch Electrical Connector
    GF0032008Courtesy of FORD MOTOR CO.
  4. Install the center console trim cover.
    5. Fig 4: Identifying Center Console Trim Cover
    GF0031997Courtesy of FORD MOTOR CO.

    MKX 

  5. Install the selector lever trim ring.
    6. Fig 5: Locating Selector Lever Trim Ring
    GF0031996Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals